How to tie a handfasting cord

I am by no means an artist, so please forgive the quality of the diagram, however I would hope that it may help you visualize the process of handfasting a little better.

  1. With the couple facing the guests and the officiant standing behind them, hold hands [the two hands that are naturally together, brides left, grooms right] Take centre part of cord to a loop and thread upwards from under the hands to just above the hands. The hands should be between the cord and the officiant.
  2. Drop the loop down over the hands towards the officiant.
  3. Pass the two ends of the cords through the loop under the hands.
  4. Pull to neaten. Repeat for each cord. [you can let go of the cords at this time.
  5. Once all the cords are looped over, gather the ends and make the knot. If you have looped correctly, the couple can remove their hands and the knot stays tied. Do not tighten too much, allow the room to remove the hand.

8 thoughts on “How to tie a handfasting cord

  1. Pingback: Handfasting Vows - Tulsa Alternative Ceremonies | Tulsa Alternative Ceremonies

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s